Sensor Adapter:
Female XLR to
Male 3-pin Sensor

This adapter makes it possible to plug any of our sensors into the pin-block on the Teabox, an I-Cube, or a breadboard (such as the one on the Basic Stamp BOE).

 

Adapter Specifications

This cable is built with a 1-meter (3 feet) length of Canare L-4E5C cable, Neutrik XLR, and Molex 3-pin connectors. All of our cables are fully tested before we ship them.

The pins are mapped as follows:

• XLR Pin 1 (Ground) is connected to Pin 1 (the pin with the arrow on it) on the 3-pin sensor connector.
• XLR Pin 2 (Power: +5V) is connected to Pin 3 on the 3-pin sensor connector.
• XLR Pin 3 (Sensor Output) is connected to Pin 2 (the middle pin) on the 3-pin sensor connector.

The adapter cable is shielded with braided shield to provide excellent performance, flexibility, and durability.