Sensor Adapter:
Male XLR to
Locking Female 3-pin Sensor

This adapter provides a locking 3-pin (sensor) input and a high-quality XLR male connection. This adapter is good for taking sensors with 3-pin outputs (such as some I-Cube sensors) and converting the pin format to run over XLR cables. This adapter comes standard with most Electrotap sensors.

 

Adapter Specifications

This cable is built with a 1-meter (3 foot) length of Canare L-4E5C cable, Neutrik XLR, and Molex 3-pin connectors. All of our cables are fully tested before we ship them.

The pins are mapped as follows:

• XLR Pin 1 (Ground) is connected to Pin 1 (the pin with the arrow on it) on the 3-pin sensor connector.
• XLR Pin 2 (Power: +5V) is connected to Pin 3 on the 3-pin sensor connector.
• XLR Pin 3 (Sensor Output) is connected to Pin 2 (the middle pin) on the 3-pin sensor connector.

The adapter cable is shielded with braided shield to provide excellent performance, flexibility, and durability.